The EP Greenhouse gear driver is a concise and lightweight reduction gear motor with a built-in limit switch system that is suitable for assembly of a locally available electric electric motor. The gear motor is utilized in manually-managed or climate-controlled ventilation and display screen systems in greenhouses. The quick and easy-to-install EP gear motor can be rainproof and windproof. The gear reducer has a high protection class (IP65) and can be utilized in an ambient temperature of 0-60 °C.
The low-noise gear motor for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel transmitting means that the drive shaft is certainly locked when the decrease geared motor isn’t running. The completely sealed reduction reducer has an growth chamber with a diaphragm to keep carefully the gear essential oil at a minimal pressure under all circumstances, even at high temperature ranges. Thanks to the utilization of an growth chamber, the gearbox can be installed in any placement. There are no limitations, because there is no dependence on a bleed connect. The sealed reduction gear motor keeps the gear essential oil of the geared motor in ideal condition because of its entire operating lifetime. The gear motor is suitable for discontinuous use, operating class s3-30%, with a maximum activation period of 25 minutes.
The Gear box reduction gearbox comes with an FT85 motor assembly flange, on to which the right IEC standard motor can easily be installed (EN 50347).
The Gear box includes a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off at the end positions. The limit change system is installed in an integrated chamber and is usually enclosed by an impact-resistant plastic material cover. The limit switch system is obtainable and simple to adjust. The limit switch system’s maximum switching range is usually 40 or 64 revolutions of the drive shaft. The cabling is connected in spring-clip connections. The gear driver comes with an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.
The gearbox for greenhouse comes with 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates are available as accessories.
Maximum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in the event of program of 4-pole electric motor.
Protection class IP65.
May be used in ambient temperatures of 0-60°C.
Suitable for discontinuous use, operating class s3-30%, maximum activation time 25 minutes.
Equipped as standard with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installing IEC regular motor (EN 50347).
Maximum switching range of limit switch system 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).